How To Mount; Control Toggle Switch; Button Hold Function - HORI nsw 228u Manual De Instrucciones

■ How to Mount

Steering Unit
Option 1: Suction Cup
Remove all dust and dirt from your tabletop
before securing the controller using the five
suction cups.
Attach suction cups to steering unit when
setting up.
・ Do not combine both securing methods as it may damage the suction cups.
・ Do not affix to furniture made from glass or other fragile materials.
・ Detach from furniture carefully to prevent damage to furniture or product.
Foot Pedals
Place foot pedals onto a flat surface.

■ Control Toggle Switch

Directional pad controls can be toggled to directional pad, left stick or right stick controls.
This product's directional pad toggle function is not guaranteed to work with all software.
・Please refer to software's instruction book. This product does not work with Analog mode.

■ Button Hold function

Push and hold the Hold button to maintain the pushed state after releasing your finger.
How to Enable
How to Disable
Button Hold function works only when ITEM button has ITEM function.
CAUTION
While the Button Hold function is enabled: If you want to use the item you pick up,
press any of the ZL button / ITEM button / L Paddle once to disable the Button Hold function.
Then press the button again to use the item.
4
Directional pad
Press for 1 second
Press Once
ZL button / ITEM button / L Paddle
When playing Mario Kart
Option 2: Clamp
Tighten the clamp screw into the steering wheel
base.
Use the clamp to secure the steering unit to a flat,
hard surface (i.e. table).
Left stick Right stick
Red LED turns on.
Red LED turns off.