Tripp-Lite PDU15NET El Manual Del Propietario página 5

Features
PS/2 Port: Use this port to connect a Tripp Lite
ENVIROSENSE environmental sensor to provide remote
temperature/humidity monitoring and a dry contact
interface to control and monitor alarm, security and
telecom devices. Contact Tripp Lite Customer Support at
(773) 869-1234 for ordering information.
Note: Do not connect a keyboard or mouse to this port.
Configuration Port: Use this port to provide a direct
terminal connection to a computer with a terminal
emulation program. A configuration cable (part number
73-1243) is included with the PDU. If you need to order a
replacement cable, contact Tripp Lite Customer Support at
(773) 869-1234.
Ethernet Port: Use this RJ-45 jack to connect the PDU to
the network with a standard Ethernet patch cable. The
Link LED and Status LED
A
conditions, as shown in the table below. This port is not
compatible with PoE (Power Over Ethernet) applications.
Network Operating Conditions
A
Link LED Color
Off
Flashing Amber
Flashing Green
B
Status LED Color
Off
Steady Green
Flashing Amber
SNMP Reset Button: The SNMP reset button
recessed in a small opening between the Link and Status
LEDs. To reset your SNMPWEBCARD, use a small tool to
press the reset button for 3 seconds. Rebooting the
network card will not erase network settings or interrupt AC
power.
15-09-410-9334F3.indb 5
indicate several operating
B
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
Card Not Initialized
Card Initialized and Operational
Error - Card Not Initialized
5
A
is
C
B
C
10/30/2015 9:44:19 AM