Sleep Timer; Setting The Alarm Time - Silvercrest SWED 200 A1 Manual De Instrucciones E Indicaciones De Seguridad

SLEEP timer

With the SLEEP timer, you can set a time between 10 and 90 minutes after
which your world receiver (A) automatically switches off. The setting is
made in intervals of 10 minutes. Proceed as follows:
 Switch off the device with the "POWER" button (8).
 Press the "POWER" button (8) for approximately one second until a
beep sounds and the number 90 (for 90 minutes) is indicated on the
display (7).
 Then press the "POWER" button (8) repeatedly until you reach the
desired number of minutes (for example, 40). Each time you press the
"POWER" button (8), the number of minutes to switching off is reduced
by 10 minutes.
 Now the multi-band tuner (A) switches on and automatically off after the
set countdown time (e.g. 40 minutes) has elapsed.
 The display (7) indicates "SLEEP" (25) when the SLEEP timer is activated.
 You can change the frequency band, start the station scan, access
saved stations and adjust the volume even when the SLEEP timer is
activated.
 You can delete the activated SLEEP timer by switching off the device.

Setting the alarm time

You can set one alarm time. Make sure that the time is set correctly. You
can set the alarm time only when the device is switched off. Switch off the
device with the "POWER" button (8) if it is switched on. If no button is
pressed for 3 seconds, the device returns to normal operating mode.
SilverCrest SWED 200 A1
English - 55