Safety Instructions; Electrical Connections - Balluff HEARTBEAT BAE00M3 Guia De Inicio Rapido

Switching power supplies IO-Link ready
MAN-SHG BAE PS-XA-1S-24-200-104
EU Directive 2004/108/EC (EMC Directive)
Low Voltage Directive 2006/95/EC
Product standard EN 61204-3. Safety of Information Technology Equipment EN 60950
Scope
This guide is valid for the following devices:
– BAE PS-XA-1S-24-200-104 (ordering code BAE00M3)

Safety instructions

Before commissioning, read the user's guide
carefully!
These devices must not be used in applications
in which the safety of persons is dependent on
the function of the device (not a safety compo-
nent acc. to EU Machinery Directive).
DANGER from high voltages!
Contact with unprotected conductors and
components can result in a fatal electric shock
or severe burns.
Before starting work on the device, interrupt the
power supply and secure against restart. Do not
insert foreign objects into the device. Keep
away from fire.
Installation and commissioning must only be perfor-
med by trained specialist personnel.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take measures to ensure
that a defect in the device will not result in hazards to
persons or equipment.
If defects and persistent faults occur in the
switching power supply, take it out of service and secure
against unauthorized use.
www.balluff.com
Download of the user's guide
The user's guide can also be found on the internet at
www.balluff.com.
Intended use
This device is a primary switched-mode power supply for
integration in control panel installations or integral applica-
tions where access to the power supply is restricted
(contact protection). The device is suitable for contamina-
tion class 2.
Modifications to the device or non-approved use are not
permitted and will result in loss of warranty and void any
liability claims against the manufacturer.
Installation
Attention!
Connect the device to mains in accordance with
local regulations and standards.
Do not cover the device! Ensure that there is
sufficient space around the device to allow for
cooling, otherwise the device may shut down
due to overheating. The service life of the device
is shortened once it is operated for a longer
period of time in an overheated state. The stress
level indicator signals inadequate cooling.
The housing may become hot during operation!

Electrical connections

– Data for permissible loads, see table "Technical data".
– Only use commercial cables suitable for the specified
current and voltage values.
– For flexible cables, make sure that all strands are
secured in the terminal.
– Make sure the polarity at the output is correct.
– Always switch the power off before connecting or
disconnecting plug connections.
– If necessary, a manually controlled element for isolating
the mains power supply must be used.
– Device and power cables must be fused correctly.
– The unsecured ground conductor must be connected
to GND (insulation class 1).
– The secondary side is not grounded. If necessary, the
plus or minus terminal can be grounded.
– Do not modify the installation while the device is opera-
ting! The same applies for the secondary side. Danger
from electric arcing and deadly electric shocks.
English 1