Candy CCVB 30/1 Instrucciones De Instalación página 8

OPERATING YOUR WINE COOLER/BEVERAGE COOLER
 Control System Instruction
" " Button
•
To control this appliance turn on/off
3 seconds).
" " Button
•
To control the inner light turn on/off.
" " Button
•
Used to raise(warm) the temperature in 1℉（1℃）.
" " Button
•
Used to lower(cool) the temperature in 1℉（1℃）.
"ο"
•
Indicator light illuminates to signify the cooling mode is currently in operation.
"DISPLAY"
•
To shows the temperature of the set temperature.
 Setting The Temperature Controls
Set the desired cooling temperature by pressing the buttons adjacent to the "
indicators. Each press of the buttons will scroll through the available temperature settings in
increments of 1°C.
The temperature setting can be adjusted from 5℃ to 18℃.
If you want to reveal every indoor actual temperature, please press and hold the "
" " button for 3 seconds, the LED will flash and display the actual temperature. After
stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to
display the set temperature.
Flashing LED = Cabinet temperature
Steady LED = Set temperature
If the temperature inside is higher than 23 ℃, it will display "HI" on the display panel, and after one
 Temperature Alarm
temperature inside is lower than 0 ℃, it will display "LO" on the display panel and at the same time
hour after the alarm / buzzer will sound. This indicates that the temperature inside is too high. If the
the alarm also malfunction indicator is active
AND SETTING THE TEMPERATURE CONTROL
( press and hold this buttons for approximately
7
" or " "
" or