Cold Laminating Procedure; Adjust Retractable Cooling Arms To The Size Of Film - Royal Sovereign ES-1300C Manual Del Propietário

COLD LAMINATING PROCEDURE

NOTE: When switching the machine from the hot to cold mode, it will take
approximately 40 minutes for the ready indicator light to turn off. Please wait
for the light to turn off before inserting your document.
ADJUSTING RETRACTABLE COOLING ARMS TO THE SIZE OF THE FILM
Picture 6
1 ) When machine is not
in use, Please store
machine as shown in
Picture 6.
1. Turn the power switch to the cold position ("o").
The ready indicator light will not light, but the
machine is now ready to laminate in the cold
mode.
2. Place the document to be laminated on the
adhesive side of the cold film with the document
face up.
3. Insert the document to be laminated into the front
opening of the machine.
4. Remove paper liner from the cold film slowly
while the document is being inserted into the
machine.
Picture 7
2 ) When using small
pouches, Please
refer to Picture 7.
7
ES-1300C
Picture 8
3 ) When using A4 size
film, Please refer to
Picture 8.