Cold Laminating Procedures; How To Use Cleaning Paper - Royal Sovereign APL-230 Manual Del Usuario

COLD LAMINATING PROCEDURE
1. Place the laminator on a flat, sturdy work surface.
2. Plug the laminator into a power source that matches the laminator's rate
of voltage.
3. Turn the temperature control switch to the COLD position.
4. Switch the power switch to the RUN position. (Power light will light up)
5. Adjust the temperature control switch according to pouch thickness.
6. Wait for the READY light to light up.
7. After the READY light is lit, place item to be laminated into a pouch and then
into the front opening of the laminator.
Power switch

HOW TO USE CLEANING PAPER

1. Turn the machine on, after the READY light is lit up, remove the dirt on
the rollers by passing the Cleaning Paper through the machine once or twice.
2. If the outside of the Cleaning Paper gets dirty, fold the cleaning paper
inside out.
3. If the Cleaning paper is bad or you can not use both-sides of the Cleaning
Paper, get new white coated paper at the nearest stationery shop.
All manuals and user guides at all-guides.com
Temperature control switch
6
APL-230/330