Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To disinfect the drum:
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the drum.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
3. Empty drum after 20 minutes. Rinse
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
cord Wrap and maintenance
(Ws1600cAeX0)
When vacuuming is complete, unplug
the cord and wrap it around the power
assembly push/pull handle, as shown.
The cord should wrap under the pull
handle (above the inlet) and around and
under the cord wrap of the power head
assembly.
(Ws1200vAeX0)
When vacuuming is complete, unplug
the cord and wrap the power cord around
the power head and snap the connector
on the plug to a wrap of the cord, as
shown.
If the power cord is damaged, it must be
replaced by the manufacturer to reduce
the risk of accident.
mAINTeNANce (continued)
Push/Pull
Handle
Power
Cord
Power Head
Assembly
Power Head
Assembly
Power
Cord
storage
Before storing your Vac, the drum should
be emptied and cleaned. The cord should
be wrapped around the unit and the hose
should be stored as described in this
manual. Accessories should be kept in
the same area as the Vac so they can be
readily available. The Vac should be
stored indoors.
casters and Wheels
Should your cart squeak or become hard
to roll, you should place two or three
drops of general purpose oil on each
wheel at the axle. If your casters are
noisy, you may put a drop of oil on the
roller shaft to make them quieter.
frame and handles
(Ws1600cAeX0)
Your metal handle is painted to prevent
rust, however, liquids and corrosive
debris should be wiped off with a soft
cloth should they come in contact with
the handle.
WARNING: To assure product
sAfeTY and RelIAbIlITY, repairs
and adjustments should be performed
by Authorized service centers, always
using WoRKshoP replacement parts.
18
Publicidad
Capítulos
Tabla de contenido
