JB Systems STEALTH Manual De Instrucciones página 3

ENGLISH
FUNCTIONS
1. KEY-ACTUATED POWER SWITCH: Used to switch the laser on/off, only to be
used by authorized personnel.
2. MICRO: The built-in microphone is used to synchronize the laser show to the
beat of the music.
3. MAINS INPUT: This Power socket has a built-in fuse holder with 2A fuse.
Connect the Stealth Laser to the 220V AC mains, using the supplied power-cord.
4. MASTER / SLAVE SWITCH: Used to change the operation mode.
• When used as a single unit or as master in a setup with several units, put
the switch in MASTER mode.
• When used as one of the slaves in a setup with several units, put the
switch in SLAVE mode.
5. INPUT / OUTPUT XLR-CONNECTORS: When the laser is used in a setup with
several units, they can work in synchronized mode. The input/output connectors
are used to connect the units, using a good quality balanced signal cable with
XLR-♂ and XLR-♀ connectors like for example JB Systems signal cable "7-0063"
6. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input
sensitivity. Turn the potentiometer until the laser works in sync with the music.
7. FAN: Take care that the fan is always free of any dust. It assures good cooling of
the unit which means better performance and extended life!
INSTALLATION
SINGLE UNIT
The installation is very simple:
1. Fix the laser unit in a safe way and adjust the suitable angle.
2. Set the MASTER / SLAVE switch to "MASTER"
3. Connect the Laser to the 220V AC mains, using the supplied power-cord.
4. Put on some music and adjust the music input level.
JB SYSTEMS 3/16
OPERATION MANUAL
STEALTH LASER