Harbor Breeze 40198 Manual Del Usuario página 10

STANDARD OR ANGLED MOUNTING INSTRUCTIONS
3 . Slide the downrod (A) into the yoke of the motor
assembly (E), align the holes, and re-install the
downrod clip (GG) and pin (FF) . Then re-tighten
the motor housing set screws (HH) and slide the
yoke cover (F) down until it rests on top of the motor
assembly (E) .
Haodwaoe Used
FF
Downrod Pin
GG
Downrod Clip
Motor Housing
HH
Set Screw
4 . Depending on the length of downrod (A) you use,
you may need to cut the lead wires back to simplify
the wiring . If you decide to cut back the lead wires,
it is suggested that you do so in the following
manner: Take the lead wires and make sure that
you have pulled them all the way through the top of
the downrod (A) and measure 8 in . of lead wire, and
then cut the excess wire off with wire cutters (not
included) .
3
x 1
x 1
x 2
4
10
F
GG
HH
Lowes.com/harborbreeze
A
FF
E
A