Thermador VTR1400Q Instrucciones página 3

IV. ONCE INSTALLATION IS COMPLETE:
1. Turn ventilator on High for 5 minuts to ensure
proper installation.
2. Step to Medium & Low ensuring each speed setting.
3. Turn ventilator off.
Installation must comply with all local codes
KITCHEN VENTILATION TIPS
1. Cooking Appliances such as Ranges, Cooktops,
Barbecue Units, Grills, etc., require adequate venti-
lation. Hood should be large enough and Cooking
Appliances located so that the Hood overhangs the
Cooking Surface as much as possible.
2. Consult a Competent Kitchen Designer or Ventila-
tion Engineer for proper Hood size and C.F.M.
requirements.
3. Provide make-up air input to the kitchen so ex-
hausted air is not drawn through furnace unit or
down fireplace chimney.
4. Locate the Cooking Area for minimum cross drafts,
away from doors and windows, etc., when possible.
5. For best performance duct runs should be as short
and as straight as possible. Where turns are neces-
sary, keep turning radius as large and as smooth as
possible.
Fig. 8
VTR600R/VTR1000Q/VTR1400Q: WIRING DIAGRAM FOR WALL MOUNT FOUR (4) POSITION
SWITCH MODEL # CTR3Q
6. WARNING - TO REDUCE THE RISK
OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high set-
tings. Boil-overs cause smoking and greasy spillovers
that may ignite. Heat oils slowly on low or medium
settings.
b) Always turn hood ON when cooking at high heat or
when cooking flaming foods.
c) Clean ventilating fans frequently. Grease should not
be allowed to accumulate on fan or filter.
d) Use proper pan size. Always use cookware appro-
priate for the size of the surface element.
Fig. 7
WARNING:
Disconnect power before installing switch.
Before turning power on, be sure that all
controls are in the OFF position.
3
(not provided)