Evolution RAGE-B Instrucciones Originales página 18

(10.3) CUTTING ADVICE
WARNING: The operator should wear all
relevant PPE (Personal Protection Equipment)
necessary for the job at hand. This could
include safety glasses, dust masks, safety shoes
etc. The operator should always be aware of
the position and routing of the power cable.
(10.4)
• Do not force the machine.
• Allow the speed of the saw blade do the
work. Cutting performance will not be
improved by applying excessive pressure to
the machine, and blade life will be reduced.
• When using the parallel edge guide, ensure
that it is parallel with the blade. The blade
and/or motor could become damaged if
the machine is used with an incorrectly
adjusted parallel edge guide.
• Place the front edge of sole plate squarely
on the workpiece, ensuring that the saw
blade is not in contact with the workpiece,
before starting the motor.
• When starting a cut, sight the cutting line
with the line of cut guide, taking care to
introduce the blade to the material slowly,
so as not to damage its teeth.
www.evolutionpowertools.com
Note: Two (2) line of cut guides (for 0
bevel angle only) are positioned on the front
edge of the sole plate.
• Use both hands to move the saw forwards
through the workpiece.
• Apply smooth, constant pressure to move
the saw forwards through the workpiece.
When a cut has been completed release the
ON/OFF trigger switch and allow the blade to
come to a complete halt. Do not apply lateral
pressure to the blade disc in an attempt to
slow it down more quickly.
(10.5) WARNING: If the motor should stop
or stall whilst a cut is being attempted release
the trigger switch immediately and disconnect
the machine from the power supply. Remove
the machine from the workpiece before
investigating the cause and attempting
to restart the motor.
18
and 45
0 0