Retrieving I/M Readiness Status - BGS technic 63311 Manual De Instrucciones

3) If the retrieved information covers more than one
screen, use SCROLL button, as necessary, until all data
have been shown up.
The number "x/x" to the upper rig ht corner of the screen indicates total number of screens the
retrieved freeze frame covers and sequence of currently displayed data.
If there is no freeze frame data available, an advisory message "No Freeze Frame Data Stored!"
shows on the display.
4) Press ENTER/EXIT to return to Diagnostic Menu.

4.6 Retrieving I/M Readiness Status

I/M Readiness function is used to check the operations of the Emission System on OBD2 compliant
vehicles. It is an excellent function to use prior to having a vehicle inspected for compliance to a state
emissions program.
Some latest vehicle models may support two types of I/M Readiness tests:
A. Since DTCs Cleared - indicates status of the monitors since the DTCs are erased.
B. This Drive Cycle - indicates status of monitors since the beginning of the current drive cycle.
An I/M Readiness Status result of "NO" does not necessarily indicate that the vehicle being tested will
fail the state I/M inspection. For some states, one or more such monitors may be allowed to be "Not
Ready" to pass the emissions inspection.
"OK" -- Indicates that a particular monitor being checked has completed its diagnostic testing.
"INC" -- Indicates that a particular monitor being checked has not completed its diagnostic testing.
"N/A" -- The monitor is not supported on that vehicle.
1) Use SCROLL button to select I/M Readiness from
Diagnostic Menu and press ENTER/EXIT.
If more than one module is detected, you will be
prompted to select a module before test.
Use SCROLL button to select a module and press
ENTER/EXIT button.
2) Wait a few seconds while the code reader validates
the PID MAP.
11