Maintenance; Cleaning; Desktop Smart Charger And Calibrator - Cuda surgical ELITE 8500B Operación Manual

The system comes with gown clips to relieve the weight of the cable from the headband.
One gown clip is attached below the shoulder.
Once the battery is depleted into the last shown "block" on the power gauge, the unit may
beep once to indicate low battery levels. The unit may beep twice to indicate further
reductions in power before shut-down.

4. MAINTENANCE

Storing the headlight system in a safe place will prolong the life of the unit.
The following guidelines will help in sustaining the headlight system useful life:
Keep the optical faces of the LED Headlight lens from touching hard surfaces,
•
which may cause scratches on the surface. Scratches on the surface will
diminish the light output. Using the lens cap during transport will help protect the
lens.

5. CLEANING

The headlight module can be wiped down with alcohol. The lens should be cleaned only
with lens tissue, available in any camera store; follow the directions on the package.
Follow all applicable bloodborne pathogen procedures as required by OSHA and/or your
hospital, when cleaning and disinfecting the product.
The headband can be cleaned with a alcohol wipe down or washed with a
lukewarm solution of water and mild detergent. Rinse thoroughly.
Do not autoclave the LED Headlight module, headband, cable,
battery or battery holster.

6. DESKTOP SMART CHARGER AND CALIBRATOR

Safety
1. Do not expose the charger or power supply to water or liquids; this is not a sealed case.
2. Do not open the charger or power supply case, no user serviceable parts are inside.
3. Do not cover the fan exhaust or obstruct the airflow, this will cause overheating.
4. Use only the manufacturer's power supply and observe terminal polarity.
5. Place the charger in a cool spot, away from external heat sources
During recalibration the charger may become warm.
®
LIT-221 CUDA
(English)
Rev. -
Date of Revision:07/20/16
Page 5 of 51