Operation; Control Panel And Remote Control - LG W122HE SC0 El Manual Del Propietario

OPERATION

Control Panel and Remote Control

2 3
6
4 5
Power
1
Press to turn the air conditioner ON or OFF.
Operation Mode
2
Press the Mode button to cycle between
4 types of air conditioner operation: Energy
Saver (AA.Energía) / Cool (Frío) / Fan
(Vent.) / Heat (Calor).
Energy Saver (AA.Energía) - In this mode
the compressor and fan turn off when the
set temperature is achieved. Approximately
every 3 minutes the fan turns on to allow
the unit sensor to accurately determine if
more cooling is needed.
Cool (Frío) - This mode is ideal on hot days
to cool and dehumidify the room quickly.
Use the Temp
desired room temperature and use the Fan
Speed (V.vent) button to set the desired
fan circulation
Fan (Vent.) - In this mode the fan circulates
air but the compressor does not run. Use
the Fan Speed (V.vent) button to set fan
speed to High, Medium or Low. In this mode,
you cannot adjust the set temperature.
Heat (Calor) - Heater runs and heats the
room.
7
1
buttons to set the
Remote Control
Temp
5
Fan Speed
Timer Mode
3
Delay ON/OFF Timer
3
Delay ON - When the air conditioner is off,
set it to automatically turn on from 1 to 24
hours later, at its previous mode and fan
settings.
Delay OFF - When the air conditioner is on,
set it to automatically turn off from 1 to 24
hours later.
NOTE
● Each press of the Timer (Tiempo) button
advances the timer by 1 hour. After the
last press the display returns to the
temperature setting.
Fan Speed
4
Press to set the Fan Speed (V.vent) to Low
(F1) or High (F2).
Temperature Control
5
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 16 °C–30 °C
(60 °F–86 °F). Press
increase or decrease temperature setting.
EN
OPERATION 13
1
4
2
or arrows to