14
OPERATION
Clean Filter (Limpiar filtro)
6
The Clean Filter LED lights up to notify you
together on the control panel to turn off the
Clean Filter light.
NOTE
●
control panel, not the remote control.
● This feature is a reminder to clean the air
light turns on after 250 hours of operation.
Remocon Signal Reveiver
7
A slight heat odor may come from the unit
when first switching to HEAT after the
cooling season is over. This odor, caused
by fine dust particles on the heater, will
dissipate quickly.
NOTE
● Auto Restart: If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver: The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
Wireless Remote Control
Inserting Batteries
Temp
and
1
2
3
NOTE
● New battery are supplied with the air
● Do not use a rechargeable battery. Make sure
● In order to prevent discharge, remove the
● Keep the remote control away from extremely
● To maintain optimal operation of the remote
Remove the cover on the back of the
remote control.
Pay attention to polarity and insert one new
AAA 1.5V battery.
Reattach the cover.
conditioner for use in the remote control.
that the battery is new.
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
hot or humid places.
control, the remote sensor should not be
exposed to direct sunlight.