Installing A Pre Wound Reel; Replacement Parts - Cub Cadet CC 3075 Manual Del Operador

Maintenance (continued)
Fig. 6-5
Fig. 6-6
Fig. 6-7
Fig. 6-8
14
12. Insert the ends of the line into the two holding slots
13. Insert the ends of the line through the eyelets in the
NOTE: The spring must be assembled on the inner
14. Hold the inner reel in place and install the Bump

Installing a Pre Wound Reel

1. Hold the outer spool with one hand and unscrew the
2. Remove the old inner reel from the outer spool
3. Remove the spring from the old inner reel
Loop
4. Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner
5. Insert the ends of the line through the eyelets in the
6. Place the new inner reel inside the outer spool. Push
7. Hold the inner reel in place and install the Bump
Holding Slots

Replacement Parts

For replacement parts, refer to the Accessories /
Replacement Parts section.
Spring
(Fig. 6-7).
outer spool and place inner reel with spring inside the
outer spool (Fig. 6-8). Push the inner reel and outer
spool together. While holding the inner reel and outer
spool, grasp the ends and pull firmly to release the
line from the holding slots in the reel.
reel before reassembling the cutting
attachment.
Knob by turning counterclockwise. Tighten securely.
Bump Knob clockwise (Fig. 6-1). Inspect the bolt
inside the Bump Knob to make sure it moves freely.
Replace the Bump Knob if damaged.
(Fig. 6-1).
(Fig. 6-1).
reel before reassembling the cutting
attachment.
outer spool (Fig. 6-8).
the inner reel and outer spool together. While holding
the inner reel and outer spool, grasp the ends and
pull firmly to release the line from the holding slots in
the spool.
Knob by turning counterclockwise. Tighten securely.