Publicidad
Idiomas disponibles
Idiomas disponibles
Owners Instructions
Retractable Industrial
Extension Cord Reel
Model No. : LG3040 1239 & LG3050 1439
CAUTION: Read all instructions and warnings before Operating!
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
WARNING: To avoid serious injury or death from electrical
shock or fire.
1. DO NOT handle this fixture or try to plug it in when your hands
are wet or damp or when you are standing on a wet or damp
surface or in water.
2. This fixture MUST ALWAYS BE USED in accordance with all
electrical and safety codes and ordinances, including the most
recent National Electric Code (NEC) and with the Occupational
Safety and Health Act (OSHA) Volume 1 on General Industry
Standards and interpretations.
3. ALWAYS make certain that the power source conforms to the
requirements on the fixture.
4. ALWAYS disconnect the power before servicing or inspecting
the fixture for any reason.
5. This fixture IS ONLY FOR USE ON 110-125V and is equipped
with an approved 3 conductor cord with a 3-prong, grounded
plug. TO REDUCE THE RISK OF ELECTRICAL SHOCK, it
should only be plugged into a properly grounded 3-prong outlet.
6. FIXTURE IS NOT WATERPROOF and is not intended for use in
showers, saunas or in potentially wet locations. ALWAYS keep
this fixture away from sinks, tubs, showers, etc. NEVER attempt
to pick up plugged-in power tools or appliances should they fall
into standing water. Fatal Electrocution could result!
7. This fixture comes equipped with a 3-prong grounded plug. DO
NOT remove the 3rd prong or otherwise try to modify the plug. If
it will not fit the outlet, have the proper outlet installed by a
qualified electrician. Improper connection of the grounding
conductor can result in a risk of electrical shock.
8. NEVER attempt to plug the fixture into a non-grounded outlet or
extension cord and ALWAYS be sure that the extension cord is
in good electrical condition.
9. This fixture is intended for use as a general indoor power
source. DO NOT use in potentially dangerous locations, such as
in flammable or explosive atmospheres.
10. Keep away from heating vents, radiators, or other sources of heat.
11. KEEP OUT OF REACH OF CHILDREN.
ELECTRICAL RATING
WARNING: DO NOT OVERLOAD!
Check the amperages of the tools or appliances to be
plugged into the outlets of the extension cord reel.
Listed below are the maximum amperage ratings.
Model
Cord Length
LG3040 1239
40FT
LG3050 1439
50FT
OPERATION
Plug power cord into any 110-125V standard wall outlet. Plug up to
three (3) electrical appliances into the Triple-Tap outlet.
Pull cord out to desired length and stop. If cord does not hold,
continue to pull cord slowly, stopping every four inches. This will
engage lock. To retract, pull cord out 2 to 4 inches and guide the
cord slowly back into the reel.
NOTE: 1. Outlet is un-switched and energized at all time. DO NOT
OVERLOAD !
2. DO NOT pull on cord after fully extended.
Caution: To Avoid Possible Injury - Do not allow cord to fly back
into the reel unrestricted. Guide cord slowly back into the reel.
Cord Type
Maximum outlet Rating
/Gauge
(Total for four outlets)
12/3 SJTW
125V, 15AMP, 1875WATT
14/3 SJTW
125V, 13AMP, 1625WATT
CIRCUIT BREAKER OVERLOAD PROTECTION
The reset button for the circuit
breaker is located on the side of
tri-tap. If unit is overloaded circuit
breaker will trip (black reset button
will pop out).Remove overload,
wait two minutes, then reset by
pressing black button.
INSTALLATION
Ceiling or Wall Mount
- 180° Rotation
(Fig.1 & Fig.2)
1. Select a location within 2 1/2 feet
of an electrical outlet.
2. Secure bracket "A" to a stud or
joist by the use of the 3 supplied
#12 screws.
Caution: All three screws should
be used for security of the bracket.
3. Place reel in the bracket "A".
Place the bracket part "B" into
bracket "A" until a click is heard.
The reel is now securely locked
in the bracket.
4. To remove the reel from the
bracket, depress release button
as indicated on the bracket. This
will allow bracket "B" to be slid
out of the way for removal of the
reel.
MAINTENANCE
WARNING: UNPLUG UNIT BEFORE PERFORMING ANY
MAINTENANCE.
Remove dirt and grime as soon as it accumulates. Use a soft, damp
cloth and a mild soap, if needed. Be sure not to get the electrical
plug wet. NEVER submerge any part of the Cord Reel in any
solution to clean it.
DO NOT USE solvents such as gasoline, turpentine, etc. to clean
unit.Keep reel cord clean to assure smoothest automatic retraction.
To clean, simply pull cord to its full length and allow to retract
through a dampened rag. Pull out full length again and allow to
retract through clean rag sprinkled with talcum powder.
DRY THOROUGHTLY BEFORE PLUGGING BACK INTO OUTLET.
LIFETIME LIMITED WARRANTY
All REELCRAFT products are individually tested and inspected for
defects in material and workmanship before leaving the factory.
Should your REELCRAFT product ever fail due to faulty workman-
ship or material, simply return it to the original place of purchase for
a replacement. Our Lifetime Return Policy is limited to the replace-
ment of the original purchase. No other liability, responsibility or
warranty is expressed or implied including any regarding merchant-
ability or fitness for a particular purpose.
REELCRAFT Industries, Inc.
One Reelcraft Center
P.O. Box 248, Columbia City, IN 46725-0248
www.reelcraft.com
Fig. 1
Fig. 2
07/2009
Publicidad
