English
Summary
Manual of installation, use
and maintenance
1.0. References to legislative texts . ................7
2.0. Safety precautions ...................................7
2.1 Warning . ......................................................... 7
2.2 Fire prevention measures. . ......................... 7
2.3 Air intake . ........................................................ 7
3.2 The floor .......................................................... 8
4.5 Daily use . ........................................................ 10
4.7 Using the stove during the
5.0. Instructions for maintenance ..................10
5.4 Sweeping the chimney ............................... 10
5.5 Visual examination of the stove .............. 10
6.0. Drawings ..................................................11
6.1 Figure 1 . ........................................................... 11
6.2 Figure 2 . ........................................................... 11
1.0 References to legislative
texts
Installing a stove is subject to the national legislation and
regulations.
In France, installation must be in compliance with DTU 24.2 of
December 2006.
Local regulations including those relating to national and
European standards must be adhered to when installing this
product. For countries in the European Community, this
fireplace complies with standard NF.EN 13 229: 2001/A2,
Appendix ZA.
Instructions for installation and use are supplied with the
appliance. It is essential to read it before the installation.
The fireplace nameplate is located above the door, inside the
protective casing. It gives the following information:
manufacturer (name and address), manufacturing standard,
model, technical features.
2.0 Safety precautions
Warning! The fireplace can get very hot. It is essential to
remember this in daily use, especially when children are
present.
2.1. Warnings
Any modifications to the fireplace or its installation by the
dealer, installer or user may disrupt operation and reduce the
safety of the appliance.
Mounting accessories or additional devices which are not
supplied by ATRA may have the same consequences.
This is also true if any of the elements required for operation
and safety have been removed.
The manufacturer accepts no responsibility and withdraws his
guarantee in any of the following cases :
- designing heating installations;
- heat loss studies;
- building of heat distribution ducting systems.
These areas are the speciality of a qualified, professional
installer.
2.2. Fire prevention measures
Ensure that all furniture and other inflammable objects are
not too close to the stove. See "Distance from furniture",
chapter 2.4.
2.3. Air intake
In the room where the fireplace is installed
Danger: ensure that the intake of fresh air for the appliance
operation is adapted to the room in which it is installed.