Celestron 47001 Guia De Inicio Rapido página 3

Weather Forecast – your weather station has a display of weather forecast but it does not have a
barometer and thus is just an indication for reference only and may not be accurate but just a
visual display. The company accepts no liability for any incorrect forecast. The icons are
Sunny/Partly Cloudy/Cloudy/Rainy.
Alarm Setting – Press and hold the "ALARM" button to enter the setting mode. Enter the desired
hour and minute values by pressing the up and down arrow buttons and pressing "ALARM" to set
each. Press "ALARM" to show the alarm time and the "AL." icon will be displayed briefly and
then press the "ALARM" again to have a bell appear (in the clock display area) meaning that the
alarm is enabled. To turn the alarm off (disable) press "ALARM" again and the bell icon will
disappear.
Snooze – when the alarm goes off, press "SNZ" button to go into snooze mode and the alarm will
go off again after 5 minutes (can be repeated three times). To stop the snooze, press the
"ALARM" button.
Channel – if your Sensor is set correctly to Channel 1, then a small icon
to the left of outdoor temperature display will show a "1" in a box. If you
do not have an outdoor temperature and humidity display, make sure that
the "1" is displayed and if not (shows a 2 or 3), then push the "CH"
button until is shows the "1".
Placement – the Receiver can be put on a table, desk, or other flat surface
or it can (by using a hanger cut out on the rear of the Receiver) be hung
on a wall or other location.
Specifications:
Indoor Temperature Range = 0º to +50º C (+ 32º to + 122º F)
Remote Sensor Temperature Range = -20º to + 70º C (-4º to + 158º F)
Indoor/Outdoor Humidity Range = 20% to 95% Relative Humidity
Resolution = ± .5º C ( ± 1.5º F) for temperature & ± 1.5% humidity
Clock = digital quartz
Transmission = RF433 MHz
Dimensions = Receiver – 3.1" x 1.8" x 5.6" (79mmx46mmx142mm)
Weight = Receiver - 5oz/142g
2835 Columbia St.
Torrance, California 90503 U.S.A.
www.celestron.com
Printed in China 0110
Sensor - 2.4" x 1.1" x 3.8" (61mmx28mmx97mm)
RoHS
Sensor - 3oz/85g