Paso CMDS Serie Manual De Instrucciones página 17

ENGLISH
• COMPLEMENTARY INSTRUCTIONS SHEET •
USING THE CD/MP3 PLAYER
Start up the equipment, switch on the CD player by pressing the (L) key,
then proceed as indicated:
1) The player will activate and the display will light up, indicating whether
there is already a compact disc in the player or not.
2) If there is not, press the OPEN/CLOSE (I) key to open the drive and
insert the disc. Press the key again to close the drive: the display will
show the total number of tracks.
3) The first track starts to play out automatically. If this does not happen,
press the PLAY/PAUSE key (C).
• CD *.mp3
As already described for audio CDs, the *.mp3 files will start to play
automatically once the CD has been inserted into the drive. With the
drive at a standstill, the display will show the number of folders present
on the disk and the total number of tracks.
Note: to stop playing the CD/MP3 and proceed with the possible
programming settings, press the STOP (A) key once. Remember that if
the OPEN/CLOSE key (I) is pressed the disc will be ejected, whether
the player is off or is playing.
DESCRIPTION OF THE FUNCTIONS
A) Normal playing
This is the standard operating mode, that is to say, playing the tracks in
the pre-defined order.
Press the PLAY/PAUSE (C) key to start playing track 1.
B) 'REPEAT' function
This function can be used to repeat one or more tracks at your discretion.
Two symbols are associated with this mode:
• REPEAT To repeat the track selected.
• ALL To repeat all the tracks.
The REPEAT mode can be used both in the "normal" configuration
(normal playing) and during programming.
C) 'PROGRAM' function
With the player of the PA140-MP3 it is possible to alter the sequence
in which the pieces of music are played. To do this, proceed as follows:
- Press the PROG key (D): the word 'PGM' will appear on the display
to indicate that the programming mode has been entered.
- Select the first track that you wish to play by pressing the (B) and (E)
keys.
- Press the PROG (D) key and continue until the required sequence of
pieces has been obtained
- Once you have made the complete selection, press the PLAY/PAUSE
(C) key to start playing the programme.
While the CD is being played out, the message PGM will be shown
on the display, to indicate that a sequence defined by the user is
being played. To cancel the programme press the PROG (D) key
again. The CD will continue to be played from this point in the
predefined sequence. To cancel the programme from the memory,
stopping the CD from playing out at the same time, simply press
the STOP key (A).
(*) for *.mp3 CDs, selection of the sequence is carried out on all the
files contained in the CD.
Note : The REPEAT function can also be applied to a pre-programmed
sequence. Simply press the REPEAT key once to repeat the track being
played out (REP), or twice to repeat the whole sequence (REP ALL).
.
(*)
PA140-MP3