Safety Precautions - LEGRAND PoE Manual Del Usuario

7 IR
DC 12V Heater and
Heater shield
Camera mounting
platform
CONTROL BOARD TRIGGER OUT CONNECTION
To Test Monitor
Caution : Trigger out is active to act ICR from color to black & white. If D/N Cameras with trigger in, please clarify camera trigger
voltage, please refer to the wiring diagram as below.
A: If IR trigger signal is on the high position (+5Vdc), connect the Red and Black wire to D/N trigger line +/- of camera
B: If IR trigger signal is on the Low position (+0Vdc), connect the Orange and Black wire to D/N trigger line +/- of camera.
Note: Connection to 391 774 box camera:
- Organe wire to NA port
- Black wire to G port

SAFETY PRECAUTIONS

• Please do not directly touch the sensor element.
If necessary, use a soft cloth moistened with alcohol to wipe off any dust.
• Please be extra careful not to shake the camera
• Please avoid places where there is direct sunlight
• When using this camera in places where the lighting differs greatly, please use an auto iris lens.
• Please avoid places where temperatures exceed 50° C or more, high humidity or where direct rain drops hit, frequent vibrations,
or shocks occur.
• During the night, if a minimum brightness of 0.2 Lux can not be achieved, install appropriate light fixtures.
• When the camera is not used, keep the lens or the lens cap attached to protect the sensor.
Maint control board lie under camera mounting
plateform
see below for further descrip
10
Ground wire
IEEE 802.3at PoE
Plus IN
IEEE 802.3af PoE OUT
PoE power unit
Blower
Terminal block
IR adjust
ICR wire, Black
(ground), Red (+5V),
Orange (OV)