Reassemble Mask - DeVilbiss Serenity 9352 Serie Manual Del Usuario

REaSSEmblE maSk

1
Fully insert adjustable vent
into mask body from the
outside. Ensure it is seated
flat and rotates easily within
the opening.
3
Replace mask cushion on mask body by first aligning the top alignment mark on cushion
with alignment arrow on mask body. Push the top area of cushion onto mask body, then
continue attaching along sides and bottom until cushion is completely secured. nOTE – If
necessary, adjust cushion position to eliminate wrinkles.
5
Tr
Br
Reattach headgear to mask
body. Hold the headgear so
small loop is facing up and
label is facing out. Insert the
2 top straps into the strap
openings in the forehead
rest (TL/TR). Insert the 2
bottom straps into the strap
openings in mask body (BL/
BR)
nOTE – For optimum mask performance, it is recommended that you replace your mask at least one a year. See your
DeVilbiss equipment provider for replacement information.
WaRNiNg
This nasal CPAP mask is intended for single-patient use only. The mask may be cleaned and reused on the same
person.
EN - 6
2
Insert the tabs on the forehead rest into the openings on
both sides of the forehead pad until secure.
6
TL
BL
Attach 15 mm diameter
tubing to mask body and
insert tubing into small loop
on top of headgear securing
with strap.
Silicone Gel
4
Attach forehead rest to mask
body.
A-9352