GE 29460 Manual Del Usuario página 12

Each Line on a Separate Modular Jack
1. Plug one end of the handset cord into
the handset and the other end into the
jack on the side of the base. Place the
handset in the base.
2. Plug the power supply cord into the
POWER 6V DC jack on the base and
into an AC outlet.
3. Plug the telephone line cord into the
jack marked LINE 1+2 on the back of
the unit and into a single line modular
jack you want to be line 1 .
4. Plug the other telephone line cord into
the jack marked LINE 2 on the back of
the unit and into the single line modular
jack you want to be line 2.
NOTE : The phone automatically
defaults to touch-tone dialing. To change
to pulse (rotary) dialing, see "Tone/
Pulse Dialing." If you don't know which
type of service you have, check with the
phone company.
CAUTION: Use only the ATLINKS USA 5-2495 power supply that is
compatible with this unit. Using other power supplies may damage the
unit.
12
3
4
2
2 1
DATA PORT
DATA PORT LINE 1+2 LINE 2
LINE 1+2 jack
1
POWER
6V AC
LINE 2 jack