USING THE CONTROLS
Control panel buttons shown. Operation using the remote control is the same, unless
specifically noted.
1. COOLING MODE
· Press MODE button to choose Cool
mode, the Cool mode indicator will flash.
· Press UP or DOWN button to set room
temperature between
· Press FAN button (or High/Low button)
to select high, low fan speed.
2. FAN MODE
· Press MODE button (or Fan button) to
choose Fan mode, the Fan mode indicator
will flash.
Select the fan speed by press FAN button
or press High / Low button directly.
· The temperature can not be set.
3. TIMER MODE
· When the appliance is switch off, press
TIMER button to set timer-on.
· Press Up or Down button to adjust time
from 1 hour to 24 hours. The Time
on indicator will flash.
· When the appliance is running, press
TIMER button to set timer-off.
· Press Up or Down button to adjust time
from 30 minutes to 24 hours. The Time
off indicator will flash.
NOTE
Always point the remote at the sensor. The remote may not work if the
sensor is in bright light or if there is not a clear path between the remote
and the sensor.
10
62 F to 86 F
.
4. SLEEP MODE
·
Setting sleep mode, the temperature
will rise 1
after 2 hours, and another 2
hours later, rise 1
· Then it will keep steady and low fan blow.
5. CONTINUOUS
·
After setting continuous,the unit will keep
running no matter what temperature it sets,
and E4,E1,E2 protection works.
· High fan blows.
6. DRY MODE
Press MODE button to choose Dry mode,
·
the Dry mode indicator will flash.
· Under Dry mode, don't install exhaust hose,
take out the drain plug, and lead the condensing
water to the container through water pipe.
· When first enter the Dry mode, if Ta≥59℉,
the compressor starts; if Ta≤55℉, the
compressor stops; for other conditions, it keeps
the state as before.
· Under Dry mode, fan motor acquiesces in
low speed. The fan speed cannot be changed;
· Under Dry mode, the setting temperature is
invalid, and it indicates the ambient
temperature(50℉~95℉).