Wired Lan - NEC NP2000 Manual Del Usuario

5. Setting the LAN Setting of Projector

5-3. Wired LAN

When connecting a LAN cable to the LAN port of the projector, configure the LAN settings in the
"Built-in" page of "LAN Mode" selected from On-Screen Menu.
■ Flow of setting
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
7
Step
24
Display "Built-in" page of "LAN Mode".
Select "Profiles".
Enable or disable "DHCP".
If "Disabled" (without check mark)
Input "IP Address".
Input "Subnet Mask".
Input "Gateway".
Input "DNS Configuration".
Reconnect the network.
Finalize the setting.
If "Enabled" (with check mark)