Winterizing; Troubleshooting; Frequently Asked Questions - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

Winterizing

CAUTION: The BaduJet Inspiration must be protected when freezing temperatures are expected. Allowing the product to
freeze will cause severe damage and void the warranty.
Drain all the water from the BaduJet Inspiration. Remove the product from the pool and store indoors in a warm and dry
location.
WARNING: The BaduJet Inspiration is heavy and a compact design. The unit weighs 100 lbs and will require a two person
crew to position. DO NOT lift unit by the jet nozzles. DO NOT lift by the motor. DO NOT drop the unit into the pool.
NOTE: When the winter season is over the pump will need to be checked and primed prior to start.
CAUTION: DO NOT run the pump dry. If the pump is run dry, the mechanical seal will be damaged and the pump will start to
leak at the seal. If this occurs, the mechanical seal will need to be replaced. ALWAYS maintain the proper water level in your
pool. Continued operation in this manner could cause a loss of pressure, resulting in damage to the pump casing, impeller,
and mechanical seal.
6

Troubleshooting

Frequently Asked Questions

How is the current generated?
The pump generates up to 400 GPM coming out of two (2) jet nozzles at 27 ft. per second creating a swim current in excess
of 5700 GPM, measured 6 ft. from the jet.
What size pool do I need?
The BaduJet Inspiration can be installed in any size pool. However, we recommend a minimum length of 14 ft. and a minimum
width of a 7 ft. swimming lane.
How many amps does the pump operate at?
Maximum 19.4 amps @ 230 V
What size breaker do I need?
You must use a 40 amp breaker for the 4 HP pump to avoid nuisance tripping.
Is the BaduJet Inspiration approved?
Yes. The BaduJet Inspiration swim jet system is listed with UL standard 1563 Swimming Pool Equipment and is VGB 2008
compliant.
Does it matter if the housing is installed higher or lower than the manual states?
Yes, the center of the jet must be between 10" to 13" BELOW estimated water level for proper performance of unit.
18