Important Safety Instructions; Manufacturers Warnings - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

1

Important Safety Instructions

Manufacturers Warnings

Attention Installer:
This manual contains important information about the installation, operation and safe
use of this product. This information should be given to the owner and/or operator of this equipment.
WARNING: This product must be installed and serviced by a qualified pool professional, and must conform to all
national, state, and local codes.
WARNING: Before Installing this product, read and follow all warning notices and instructions which are included.
Failure to follow safety warnings and instructions can result in severe injury, death, or property damage. Call
(800) 223-8538 or visit www.usa.speck-pumps.com for additional copies of these instructions.
When installing and using this electrical equipment, basic safety precautions should always be followed,
including the following:
READ AND FOLLOW ALL INSTRUCTIONS
1.
2. WARNING: To reduce the risk of injury, DO NOT permit children to use this product unless they are closely
supervised at all times.
3. TO REDUCE THE RISK OF ELECTRICAL SHOCK, A copper bonding connector is provided on the motor to
connect a minimum 8 AWG (8.4mm ) solid copper conductor between this unit and any metal equipment, metal
2
enclosures of electrical equipment, metal water pipe, or metal conduit within 5 feet (1.5m) of the unit.
4. DANGER: Risk of injury: If the cord provided with the unit is damaged, it should be replaced IMMEDIATELY. DO
NOT bury the cord. Connect the cord to a grounded, grounding type receptacle only.
5. CAUTION: This product is for use with permanently-installed pools. DO NOT use with storable pools. A
permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily
disassembled for storage. A storable pool is constructed so that it is capable of being readily disassembled for
storage and reassembled to its original integrity
6. WARNING: This product is provided with a ground-fault circuit-interrupter on the electrical cord. The GFCI
must be tested before each use. With the product operating, push the TEST button on the GFCI. The unit will stop
operating. Now push the RESET button on the GFCI. The product should now operate normally. If the product
fails to operate in this manner, there is a ground current flowing indicating the possibility of an electric shock.
Disconnect the power until the fault has been identified and corrected.
7. Never exceed the maximum flow rate stated on this product (277 GPM).
8. DO NOT locate this product in seating areas or on the back rests for such seating areas.
9. This unit should be mounted only per manufacturer's instructions.
10. All fittings and fasteners should be examined for damage or tampering before each use.
11. Any missing, broken, or cracked fittings must be replaced before using this product. Only genuine Speck
replacement parts may be used.
12. All covers must be securely in place when using this product. DO NOT use this product if either cover is
missing, loose, or damaged.
4