Planning; Installation (In-Ground Pools) - Speck pumps BADUJET Inspiration Manual De Servicio, Instalacion Y Funcionamiento

Planning

The BaduJet Inspiration can be installed in any size pool. We suggest a minimum pool size of 7 ft. wide, 14 ft. long and
3 / ft. deep in order to swim. Most swimmers prefer 16 ft. in length or longer. The extra length allows the swimmer to
1
2
comfortably drift back and swim up stream. (NOTE: This unit should be mounted only per these instructions. Failure to follow
safety warnings and instructions can result in severe injury, death, or property damage.) The BaduJet Inspiration contains all
necessary hardware for mounting the unit to the deck. Mounting the BaduJet Inspiration may vary with each installation. The
center line of the nozzles should be 10" to 13" below the water level for maximum e ciency.
WARNING: DO NOT locate the jet housing in seating areas or on the back rests for such seating areas.
CAUTION: All necessary screws and bolts included with the BaduJet Inspiration are stainless steel. All screws should be
HAND TIGHT. DO NOT use drills or pneumatic tools. DO NOT over tighten!
The 4 HP, self-priming, plastic pump has a single phase motor with thermal overload (no motor starter required). The 4 HP
single phase motor draws a maximum of 19.4 amps @ 230V. The unit requires a minimum circuit of 30 amps. Install a 40 amp
breaker to avoid nuisance tripping when pump is turned ON and OFF frequently. The starting current of the 4 HP motor can
reach up to 6 times the running currents.
WARNING: A licensed electrician is required for ALL wiring connections.
Figure 2 - Dimensional Drawing

Installation (In-Ground Pools)

WARNING: The BaduJet Inspiration is heavy and a compact design. The unit weighs 100 lbs and will require a two person
crew to position. DO NOT lift unit by the jet nozzles. DO NOT lift by the pump motor. DO NOT drop the unit into the pool.
The BaduJet Inspiration contains all necessary hardware for mounting the unit to the deck. Mounting the BaduJet Inspiration
may vary with each installation.
Decks with coping: The coping or a portion thereof may have to be removed where the unit will be installed.
n
Brick decks: A section of the brick has to be removed and replaced with concrete, to provide a solid anchor for the
n
unit.
8
32.0"
≤ 1.9"
CAUTION: The distance between the unit
and the inner pool wall must not be greater
than 1.9 inches due to the danger of hair or
body entrapment. If the top rail/deck will not
allow for this distance, a section will need to
be cut out so that the distance is 1.9 inches
or less.
11.6"
17.2"
16.0"