SATA AE3001 Manual Del Uso página 12

(3) Open the end cap accessory bag, take out the M8 nut, insert it into the left hexagonal hole of the reel, and tighten the M8 long bolt.
(4) Insert the subsequent reel into the lifting beam in sequence, and align the locating pin protruding from the left side of the housing with
the locating hole on the right side of the left reel. Then pat to insert it tightly and tighten the M8 long bolt.
(5) After all the reels are installed in sequence, arrange the M6 spring washer removed previously onto the stand bolt as shown in the figure,
and then tighten it with the M6 butterfly nut (so that all the reels can be fixed).
※ Note: Make sure to tighten the spring washers and wing nuts.
12
AE3001/AE3002/AE3003/AE3004/AE3005/AE3006/AE3007/AE3008/
AE3009/AE3010/AE3015/AE3016/AE3017/AE3018/AE3019
中文
EN DE RU KO PT JA ES