Installation Steps; Care And Cleaning - LUND AVS Ventvisor Instrucciones De Instalación

Installation Steps

Insert visor into window channel, front flange first.
3
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
5
4 Piece Set
Install the rear visors using the same
methods as the front visor, with the
exception of the rear side flange. Using a flat-
head screwdriver install C1 clip at end of visor
flange to compress visor into rubber window
channel.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International. We take the utmost pride in our products
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc.
™
NOTE: Actual application may vary slightly from illustrations.
Slide rear flange
under clip
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2019 Lund, Inc. All rights reserved.
Apply pressure to all flange edges to ensure proper
adhesion. Remove tape liner by pulling on free ends.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6
If the visor does not seat correctly, roll down
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
If the visor does not seat correctly, roll down
8
Repeat Steps 1 thru 8 for passenger side.
The material that your product is made from can
be recycled. Please also consider recycling the
Page 2 of 2
window and repeat Step 5.
window and repeat Step 8.
packaging that your product came in.