Publicidad
Chapter 1 Application Scope
1）SATA's vertical jacks, with a welded main body, are designed and manufactured based on the hydraulic principle. They are widely used
in professional lifting in various industries, such as vehicle maintenance, equipment installation and construction.
2）The jacks can only be used in upright position instead of sideways or upside down. They can work at temperature of -30 ° C ~ 60 ° C,
and cannot be used in places with acid, alkali and corrosive gases.
Chapter 2 Performance Parameters
Model
Specifications
97801A
2MT
97802A
4MT
97803A
6MT
97804A
8MT
97805A
10MT
97807A
16MT
97808A
20MT
97809A
32MT
978010A
50MT
Chapter 3 Application Method
1）Select a jack of the appropriate deadweight tonnage based on the weight of the work piece.
2）Select an appropriate hard level surface as the support surface and place the jack under the work piece.
3）Connect the two-section handle, insert the slotted end into the oil return valve knob, and screw it tight in a clockwise manner.
4）Pull out the handle and insert it into the socket hole and press the pump core up and down repeatedly. Then the piston rod will rise
smoothly to lift the work piece. Since the jacks come with safety limiting devices, the jacks will protect themselves in case of work
pieces over the limiting tonnage and will not work.
5） After the work piece is lifted into place, support it with use the matching jack support, and confirm that the support is firm and
strong before performing other operations.
6）After the operation is completed, take the jack support away, and put the slotted end of the handle into the oil return valve knob,
screw it slightly loosened in a counterclockwise manner, and the piston rod will gradually lower. Do not rotate the oil return valve
too fast, otherwise the work piece will fall too fast, which is dangerous.
Chapter 4 Warning
1）Be sure to read and understand all content of the Operation Instruction before operation.
2）Overloading of the jack is prohibited, otherwise the liability for accidents will not be covered by insurance.
3）The safety valve cannot be adjusted by the user, otherwise the liability for accidents will not be covered by insurance.
4）Confirm that the support surface is a hard level surface before operation, otherwise there may be danger.
5）The jacks can only be used for jacking, and a matching jack support must be used to support the work piece.
6）Unbalance loading is prohibited and it is not allowed to lift the work piece in a tilting manner, otherwise it will be dangerous and the
jack may be damaged.
7）The jacks cannot be used in places with acid, alkali and corrosive gas.
10
97801A-97810A
Minimum
Piston rod jack-
height
up height
181
115
193
120
210
136
230
150
230
150
230
150
242
150
275
165
265
160
中文
EN
DE
Extension screw
Maximum
rod height
height
48
344
60
373
70
416
80
455
80
460
60
440
60
452
/
440
/
425
RU
KO
PT
JA
ES
Dead weight
（including handle）
2.4
3.2
3.9
5
5.6
7.1
9.1
12
25.3
Publicidad
Capítulos
