4) Battery Charge Level Indicator:
Indicates that the batteries are high and measurements are possible
Indicates that the batteries are low and should be replaced immediately although
measurements are still possible
Indicates that the batteries are exhausted
5)Scanned Temperature.
6)Temperature unit, common to temperature readings and reference temperatures.
INSTALLING BATTERY:
When the battery charge level indicator shows"
immediately.Wait until the thermometer turns off automatically, then remove the battery cover by
moving it downwards. Replace the old batteries with new ones of the same type, make sure that the
polarity connections are correct. Reinstall the battery cover.
OPERATING INSTRUCTION:
1)Hold the thermometer and point it toward the target to be measured. Pull and hold the trigger
for at least 1 second to start measuring. When the thermometer is in measurement state, the
backlight and the laser are on, and the screen shows the icon "SCAN ". When you release
the trigger, the thermometer sounds 3 beeps and the laser turns off and the last temperature
reading is held on the screen. If you have not operated the thermometer for about 15 seconds,
the backlight will turn off automatically, and, If you have not operated the thermometer for
about 1 minute, the thermometer will turn off automatically.
2)When the thermometer is in ON state ( the trigger is not pulled ), you can press the
" ° C/° F " button to select desired unit: ° C or ° F.
3)When the ambient temperature is lower than 0° C or higher than 40° C, the primary display will
show "Err " ( Error ).
4)When the scanned temperature is higher than the upper limit of the thermometer's measuring
range, the primary display will show " Hi "; and when the scanned temperature is lower than
the lower limit of the thermometer's measuring range, the primary display will show " Lo ".
05225
中文
EN
DE
RU
"the batteries are low and should be replaced
KO
JA
PT
ES
13