Important Installation Information - Philips SDV2950/27 Manual De Utilizador

Safety Instructions
EN
Outdoor antennas should be grounded with an approved lighting arrest-
ing device. Local codes may apply. Use 8 AWG or larger ground wire.
Height or other restrictions on antennas may apply to your installa-
tion depending on your proximity to an airport, or local ordinances.
Take the time to plan your installation procedure. Do all assembly
work on the antenna on the ground. Raise the completed antenna
after assembly.
Do NOT work on a wet, snowy or windy day or if a thunderstorm is
approaching. Do NOT use a metal ladder.
If the antenna assembly starts to fall, get away from it and let it fall.
Remember that the antenna mast and cable are all excellent conduc-
tors of electrical current.
Do NOT install the antenna by yourself. Be sure that there are two
other people available for help.
If any part of the antenna should come in contact with a power line.
DON'T TOUCH IT OR TRY TO REMOVE IT YOURSELF. Call your
local power company immediately.They will remove it.
Should an electrical accident occur . . . DON'T TOUCH THE PERSON
IN CONTACT WITH THE POWER LINE, or you too can become
electrocuted. Instead, use a DRY board, stick, or rope to push or pull
the victim away from the power lines and antenna. Once clear, check
the victim. If he has stopped breathing, immediately administer car-
diopulmonary resuscitation (CPR) and stay with him. Have someone
else call for medical help.
Install wire antennas high enough that they will not be "walked into"
by people.
Do not install antenna wire(s) over or under utility lines.

Important installation information

The SDV2950 uses a power injector that sends a low power DC volt-
age to the antenna to drive the signal amplifier built into the antenna
though the RG-6 or RG-59 signal cable.
It is essential for proper operation of this antenna system that the
power injector be connected between the antenna and any devices
such as splitters, additional amplifers, matching transformers,
networks, etc. SEE DIAGRAM TO LEFT.
Disregarding this important notice may result in damaging the power
injector or improper operation / poor performance.
4