First Time Use - Vicks V3500N Manual De Utilización Y Mantenimiento

Using Your Vicks
Your Vicks Humidifier comes fully assembled and ready to use.

First Time Use

Read all instructions before using this appliance.
Filling the Humidifier
1.
Unpack Humidifier. Remove Fan Housing and check that the Wicking Filter is in place
in Base. Remove wicking filter and soak in cool water. Then replace in base of unit.
2.
Replace Fan Housing, being careful to seat it properly onto the Base.
3.
Place Humidifier at least FIVE inches away from walls and heat sources, on a FIRM,
FLAT, LEVEL surface. Place on a water-resistant, non-conducting surface for protection
from inadvertent spillage. Do not place any object over the Humidifier; it could block
air openings.
4.
Completely unravel power cord. Inspect power cord for signs of damage before use.
If cord is damaged, DO NOT use product, please call 1-800-VAPOR-12.
5.
Keep cord away from heated surfaces and out of the way, where it cannot be stepped
on or tripped over.
6.
Remove Tank using Tank Handle. Turn Tank over and carefully remove Fill Cap by turning
Fill Cap counterclockwise. Fill the Tank with cool tap water. WARNING: Never use hot
water - may cause damage to Wicking Filter.
7.
Make sure the circular rubber Cap Gasket (O-Ring) is in place before replacing Fill Cap
on Tank (this prevents water leakage). To tighten, turn Fill Cap clockwise.
8.
When carrying Tank always use two hands (one on Handle, one on the Fill Cap). Insert
Tank back into Base.
Operating Instructions
1.
Make sure that switch is in OFF (O) position, place the unit on a flat, stable surface and
plug cord into a 120 VAC wall outlet.
CAUTION: DO NOT PLUG IN THE CORD WITH WET HANDS; ELECTRIC
SHOCK COULD RESULT.
2.
Fill the Water Tank and replace Tank on Base.
3.
Turn switch to desired speed. Fan will start turning.
Cool Mist Humidifier
®