Display Function - SATA AE5806 Manual Del Uso

- For AGM lead-acid batteries: Select AGM mode.
- For gel-based lead-acid batteries: Select GEL mode.
Note:
- In extremely cold environments, if the battery is lower than 1.5V, charge the battery for five minutes before starting
the engine. If the first startup fails, wait for at least 5 minutes before another start.

3.3 Display function:

- The display only shows the voltage when the charger is not working.
- The charging voltage and charging percentage are displayed during charging, and the content displayed can be changed using the display
mode button.
- When the battery is fully charged, the "Charging" indicator goes out and the "Full charged" indicator lights up.
- Note: The "V" LED will light up when the voltage is shown in the digital display. The "%" LED will light up when the charging
percentage is shown in the digital display. The "V" and "%" LEDs will not light up in boost mode.
3.4 Charging:
Note:
- Please read the safety operation specifications carefully before using the charger. Otherwise, the battery may be
damaged. In serious cases, it may cause personal injury or death.
- Connect the charger and battery in the correct manner. Refer to Sections 2.2 to 2.5 in Chapter II.
- Connect the charger to an AC power socket.
- Set a suitable charging voltage and battery type according to the battery model.
- Set a suitable charging current which will directly displayed on the charger.
- Press the Start/Pause button to start charging.
- When charging is complete, press the Start/Pause button to stop charging, then disconnect the plug from the AC power socket and follow
the reverse order of connection.
18
AE5806
中文
EN DE RU KO PT JA ES