Swann Sky Voyager Instrucciones De Uso página 2

Operating Instructions
Ensure the helicopter is turned OFF before attempting to charge it.
Check the orientation of the power cable carefully when connecting it to the helicopter. If it feels
tough to insert or you need to use force, it's probably upside down!
It'll take up to two hours to charge. Don't over-charge the helicopter, and don't leave it connected to
a charger for more than an two hours.
Charging the Helicopter: The helicopter comes with a DC Power Adapter.
• Plug the DC output pin of the power adapter into the charging lead on the side of the helicopter.
• Plug the DC power adapter into a wall socket.
Replacing Batteries in the Controller:
The battery compartment is located on the rear of the
controller.
• Undo the screw with a precision screwdriver and open
the battery compartment.
• Only use alkaline batteries. Don't mix old and new
batteries.
• For more information on battery usage and safety,
consult page 6.
This helicopter uses a remote control operating at a frequency of 2.4GHz.
As this is the same wireless band as WIFI and some other devices, we strongly suggest
avoiding locations with powerful WIFI networks, as well as equipment or devices which
generate RF noise in this frequency band, such as microwaves.
2
Recharging and Battery Replacement
If left on, it won't charge.
To charge the helicopter:
Before you can fly, you need to 'pair' the helicopter and remote together.
To pair the remote:
• Turn on both the helicopter and the remote.
• Once the LEDs stop flashing, quickly move the left stick to
maximum (to the top) and then to the minimum (to the bottom).
• The helicopter will now be paired to that controller.
CAUTION: Do not touch the running
!
rotors. Do not fly above or near
someone's head. Adult supervision
is required at all times.
• Leave the helicopter connected for
two hours.
• Disconnect the helicopter.
Pairing the Remote