Machine Components; Machine Operation; General Surface Drying; Sub-Surface Carpet Drying - Tennant 609937 Manual Del Operador

OPERATION

MACHINE COMPONENTS

1. On/Off Switch
2. Adjustable Legs
3. Carrying Handle
4. 4m (15 ft) Power Cord
5. Power Cord Hook
6. Cord Grip
7. Intake Screen
8. Exhaust Snout
3
8
2

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Connect power supply cord into a grounded wall
outlet.
Grounded
Outlet
Grounding
Edge/hole
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not use machine with the use of
an extension cord.
4

GENERAL SURFACE DRYING

1. Place dryer in a corner pointing toward center of
2. Activate ON/OFF switch by selecting desired
3. Relocate dryer as surface dries.
SUB–SURFACE CARPET DRYING
Use this method for flooded carpets. This method
does not apply to carpets that are glued in place.
ATTENTION: Depending on carpet type, we
recommend that you seek professional advice
before attempting this method.
5
1. Remove all furniture from flooded area.
2. Remove surface water with an extractor.
7
3. Lift one corner of carpet from tack strip and fold
4. Place the dryer in the corner and position the
1
4
6
5. Activate ON/OFF switch by selecting desired
6. Operate dryer until carpet is dry.

MACHINE MAINTENANCE

electrocution can result. Unplug machine before
servicing.
electrical shock, do not use this fan with any
solid–state speed control device.
1. After each use wipe power cord with damp cloth
2. Each month clean dryer exterior with a
3. Each month clean intake screens of any
4. Each year, remove intake screens to clean blower
room. Adjust front legs to desired height.
speed. The forced air will dry surfaces rapidly.
back approximately one meter.
exhaust snout under the carpet pointing toward
the center of room. Make sure intake screens are
not blocked.
speed. The forced air will billow the carpet in the
center of the room.
WARNING: Hazardous Voltage. Shock or
WARNING: To reduce the risk of fire or
and always wind cord around cord hooks rather
than loosely looped over machine. Also, check
power cord for damage. If worn or damaged,
replace immediately.
nonabrasive, non–solvent cleaner.
accumulated lint or debris.
wheel, motor and intake screens with air hose.
Tennant 200 (01–00)