Assembly - HAMPTON BAY 59254 Guía De Uso Y Cuidado

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy cover (HH) from the canopy (C) by turning
the bottom cover (HH) counter-clockwise until it unlocks.
□
Loosen the two canopy screws (II) located in the bottom of the
mounting bracket (A), and turn the canopy counter-clockwise
to remove the mounting bracket (A) from the canopy (C).
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the setscrews (JJ) on the collar
on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews (JJ) on the collar on top of the fan-
motor assembly (E).
2
□
□
□
A
II
C
HH
7
Routing the wires
Route the wires exiting the top of the fan motor
assembly (E) through the decorative motor collar cover
(D) and then the center of the canopy bottom cover (HH).
Make sure the opening of the canopy (C) is on top and
insert the ball/downrod (B) through the canopy (C).
Route the wires exiting the top of the fan motor
assembly (E) through the downrod as shown.
CC
Please contact 1-855-HD-HAMPTON for further assistance.
C
HH
D
B
E
C
HH
D
B
DD
JJ
E
HAMPTONBAY.COM