Setup And Operating Procedures - Hydas Easy Free TENS Instrucciones Servicio

avoidance of such interference please see part ELECTROMAGNETIC
COMPATIBILITY INFORMATION. (p. 90)
• Never stick two adhesive gel pads to each other.
• Keep the adhesive gel pads clean and do not expose to heat or direct sunlight.
• If the gel pads do not attach or are dirty, wipe with a wet cloth or replace
with new ones.
• Do not clean the pad or adhesive gels with any chemical. Replacement pads
are available from your local distributor.
• Place the electrodes on intact skin only. Do not place on cuts or damaged
skin.
• The adhesive pads should be attached around the area of pain before
setting the stimulation mode and output intensity

6 | Setup and operating procedures

1. Insert batteries
a
Open battery cover at the back of the device.
b
Insert two „AAA" size batteries. Please pay attention to polarity.
c
Close the battery cover.
• Rechargeable batteries are not suitable for this device.
• Remove the batteries if the monitor will not be used for a month or
more to avoid relevant damage of battery leakage.
• Please do not mix use new and old batteries or different type of batteries.
• Please do not throw battery into fire.
• Avoid the battery fluid to get in your eyes. If it should get in your eyes,
immediately rinse with plenty of clean water and contact a physician.
2. How to place the adhesive gel pads on the electrode?
Each adhesive gel pad is protected by 2 layers of transparent film-one on
either side. Remove the layer of film and place that side of the gel pad to skin.
3. Attachment of electrode lead wires
a
Insert the plug into the electrode socket on the main apparatus.
b
Connect the snap-fasteners at the other end of the wire to the electrode
pads.
c
Place the electrode on your body as directed by your physician.
• Clean the wires by wiping with a damp cloth.
• Coating them lightly with talcum powder will reduce tangling and
prolong life.
24