Assemble The Outdoor Housing - Axis 231D+ Manual Del Usuario

Installing the AXIS 231D+/232D+ in the Videotec DBH24K Dome Housing

Assemble the outdoor housing

Heater and fan bracket
1. Connect the power cables (not supplied) to the connector on the heater and fan
bracket.
2. Using the supplied screws, attach the:
• heater and fan bracket to the dome (route the cables through the dome casing and
wall/ceiling mount).
• dome camera bracket to the heater and fan bracket
3. Route the connection cable (white connector inside the dome casing) through the
inner and outer dome casing and then through the wall/ceiling mount.
4. Route the network cables through the inner and outer dome casing and then through
the wall/ceiling mount.
5. Attach the outer and inner dome casings to the wall/ceiling mount and securely
tighten the safety screw on the side of the wall/ceiling mount.
6. Install the wall/ceiling mount in the intended position using suitable plugs and
screws (not supplied).
24V~IN