How To Install The Product; Recommended Tools - Axis Q60-E Serie Manual Del Usuario

AXIS Q60-E Series

How to install the product

Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
NO TICE TICE
NO NO TICE
• The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) 2.
• Mount the product with the dome cover facing downward.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.

Recommended tools

• Torx® screwdriver T20
• Torx® screwdriver T30
• Screwdriver PH2 (to change the dome cover)
• Cable shoe pliers
• Diagonal pliers
Attach the sunshield (optional)
The sunshield protects the camera against UV light and helps keep the temperature inside the
camera down.
1. Slide the sunshield over the unit holders on the camera unit.
2. Secure the sunshield using the supplied screws (T20).
Change the dome cover (optional)
The premounted clear dome cover can be replaced if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
For location of the components, see Hardware Overview on page 9.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws, the dome bracket, and the dome cover from the dome
ring.
www.a1securitycameras.com email: sales@a1securitycameras.com
Available from A1 Security Cameras
12