Aqua Medic duo Manual De Operación página 5

1. Included in shipment
The Aqua Medic heat controller duo is generally delivered with a water-resistant temperature sensor.
The unit is ready for connection. The units to be controlled (heaters, heating cables or mats) are
connected to the double socket.
2. Description
At socket No. 1, an aquarium heater can be controlled. Socket No. 2 is provided for controlling
heating cables or mats by a timer. The maximum output is approx. 1,200 Watt.
3. Installation
- Connect to 220 V power source.
- Place the temperature sensor into the aquarium and fix it with an Aqua Medic electrode holder.
After a few minutes, the actual aquarium water temperature is indicated.
Pict. 1: heat controller duo
1. Socket No. 1 – heater
2. Socket No. 2 – heating cable
3. Operation symbol "heating"
4. Arrow keys to adjust the parameter
5. Display heating cable ON – OFF
4. Adjustion
By pressing an arrow key, the display light will be turned on.
Unlock the keys: LOC appears on the upper display. The keys can be unlocked by pressing the SET
and arrow down key for 10 seconds simultaneously. Instead of LOC, the temperature is displayed.
To adjust the setpoint, press "SET" key
to be in the "HEAT" mode (Fig. 1, No. 3).
pressing the SET button shortly.
The setting "COOL" can be used when a fan is to be used for cooling at high temperatures instead of
a heater. But then the cable may not be too strong (max. 10 W per 100 liters), so only a slight flow
of the under gravel is ensured without significant heating of the water.
until the setting menu appears. First of all, the controller has
The setpoint can be changed with the arrow keys after
5