Specifications - LG WM3570HA Serie El Manual Del Propietario

44
SPECIFICATION
Problem
Wrinkling
Power is not turned on
The door does not open
when the cycle pauses or
finishes
The wash cycle time is
longer than usual
It is musty or moldy in the
tub

SPECIFICATIONS

Model WM3570H*A
Description
Electrical requirements
Dimensions
Net weight
Max. spin speed
Max. water pressure
Possible Causes
y Did you remove the load immediately after
it finished?
y Did you overload the tub?
y Did you reverse the hot and cold water
inlets?
y Is the power cord plugged in properly?
y Has a house fuse blown, a circuit breaker
tripped, or a power outage occurred?
y Is the temperature in the tub too high?
y Is the water level in washer high?
y Is the washing machine overloaded? Are
other options added to the wash cycle?
y Has the incorrect detergent been used?
y Did you clean the tub periodically?
Front Loading Washer
120 VAC @ 60 Hz
68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
27" (W) X 29 3 / 4 " (D) X 38 11 / 16 " (H), 51" (D with door open)
92kg(202.8lbs)
1300 RPM
14.5 – 142 PSI (100 – 980 kpa)
Solutions
y Remove the load immediately after it
finishes.
y Do not overload the tub.
y Hot water rinse can cause garments to
wrinkle. Check the inlet hose connections.
y Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y Reset the circuit breaker or replace the
fuse. Do not increase the fuse capacity. If
the problem is a circuit overload, have it
corrected by a qualified electrician.
y The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until the
door lock icon disappears from the display.
y Allow the washer to complete the
programmed cycle, or Press the Spin
button.
y This is normal. The washing machine
automatically adjusts the cycle time for
the amount of laundry, water pressure,
water temperature, and other operating
conditions.
y See page 37, clean the inside and outside
of the washing machine periodically.