Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation instructions for part GMOS-LAN-08
GM Data Interface
• Provides accessory power
(12-volt 10-amp)
• Retains R.A.P. (retained
accessory power)
CHEVROLET
Avalanche † *
2012-2013
Express †
2013-2015
Malibu (with single color,
monochrome display) * 2013-2015
Malibu Limited (with single color,
monochrome display) *
2016
* These vehicles have an amplifier option. Please reference the "Service Parts Identification" sticker located in the
glove box for the RPO code UQ7 or Y91. If UQ7 or Y91 are present, then the vehicle is equipped with an amplifier.
Either use the GMOS-LAN-07 interface, or bypass the amplifier.
† Only for models with NAV.
Axxess Integrate
GMOS-LAN-08
2012-2016
INTERFACE FEATURES
• Provides NAV outputs (parking
brake, reverse, and speed sense)
• Retains chimes
• Retains OnStar/OE Bluetooth
• Adjustable OnStar level
APPLICATIONS
CHEVROLET (CONT)
Silverado 2500/3500 † *
2014
Silverado † *
2012-2013
Suburban † *
2012-2014
Tahoe † *
2012-2014
Trax *
2015-2016
axxessinterfaces.com
• Designed for non-amplified
models, or when bypassing
a factory amp
• Retains balance and fade
• USB-CAB updatable (sold
separately)
GMC
Savana †
2013-2015
Sierra 2500/3500 † *
2014
Sierra † *
2012-2013
Yukon/Yukon XL † *
2012-2014
metraonline.com
Table of Contents
Connections to be made ................................................... 2
Installing the GMOS-LAN-08 ............................................ 3
Initializing the GMOS-LAN-08 .......................................... 3
Adjusting the GMOS-LAN-08 ............................................ 3
Vehicle customization ...................................................... 4
INTERFACE COMPONENTS
• GMOS-LAN-08 interface • GMOS-LAN-08 harness
• 16-pin harness with stripped leads
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Axxess GMOS-LAN-08

  • Página 1: Tabla De Contenido

    • Retains chimes • Retains R.A.P. (retained accessory power) • Retains balance and fade • Retains OnStar/OE Bluetooth • GMOS-LAN-08 interface • GMOS-LAN-08 harness • USB-CAB updatable (sold • Adjustable OnStar level • 16-pin harness with stripped leads separately) TOOLS REQUIRED APPLICATIONS •...
  • Página 2: Connections To Be Made

    • Connect the Red wire to the accessory wire. • Connect the Light Green wire to the parking brake wire Note: The relay attached to the GMOS-LAN-08 harness is only for audible turn signal clicks. No extra steps are required to retain this feature, so leave the...
  • Página 3: Installing The Gmos-Lan-08

    • While OnStar is speaking, press the VOLUME UP or VOLUME DOWN button on the steering wheel to raise or lower the OnStar level. • Connect the GMOS-LAN-08 harness to the wiring harness in the vehicle. • If the vehicle does not come equipped with steering wheel controls, locate the...
  • Página 4: Vehicle Customization

    From the DIN harness with leads on the AX-LCD harness: before calling. • Connect the Black wire to ground. • Connect the Red wire to accessory power. • Connect the Pink wire to the Pink wire of the GMOS-LAN-08 harness. ® NOWLEDGE IS OWER Enhance your installation and fabrication skills by Note: This wire will have to be soldered onto the GMOS-LAN-08.
  • Página 5: Herramientas Requeridas

    Además, no culo está equipado con un amplificador. Utilice la interfaz GMOS-LAN-08 o elimine el amplificador. quite el radio de fábrica con la llave en la posición o de encendido ni †...
  • Página 6: Conexiones Que Se Deben Hacer

    • Conecte el cable verde claro al cable de freno de mano. • Conecte el cable rojo con el cable de accesorios. Nota: El relé adjunto a la interfase Axxess únicamente es para los chasquidos audibles de la señal direccional. No se requieren pasos adicionales para retener...
  • Página 7: Instalación Del Gmos-Lan-08

    Ajuste del nivel de OnStar • Presione el botón OnStar para activarlo. • Conecte el arnés de 16 pins con conectores pelados, y el arnés GMOS-LAN-08, • Mientras OnStar está hablando, presione los botones de “SUBIR VOLUMEN” o al interfase.
  • Página 8: Personalización Del Vehículo

    • Conecte el cable negro a tierra. problemas antes de llamar. • Conecte el cable rojo a la corriente de accesorios. • Conecte el cable rosa al cable rosa del arnés GMOS-LAN-08. EL CONOCIMIENTO ES PODER ® NOWLEDGE IS OWER Mejore sus habilidades de instalación y fabricación...

Tabla de contenido