Telstar THL014010YL Manual De Instrucciones página 25

• Do not use water that is dirty, gritty or contains any chemical products, as these could impair operation
and shorten the life of the machine.
• Accessories can be used to carry out work with foam cleaners, sand spraying.
5. ASSEMBLY
• Position the washer as NEAR as possible to the water supply.
• The washer must be used standing on a secure, stable, and positioned as shown. (FIG.3)
• Fit the lance into the gun and rotating it until the two parts are completely locked (FIG. 4)
• Connect the gun to the high pressure hose (FIG.5)
• Connect the high pressure hose to the water outlet on the washer (FIG.6)
• Connect the water supply hose to female coupler (FIG.7), then connect to the water inlet of the washer.
The supply hose must have an internal diameter of at least 13mm (1/2 in.) and must be reinforced. The water
supply must be at least equal to the washer delivery capacity.
NOTE: The machine not suitable for connection to the potable water main (FIG. 14)
WARNING
The intake water temperature must not exceed 40ªC. The water supply must not exceed 0.7 MPa.
6. NAME OF PARTS: (FIG. 1-FIG.2)
CAUTION
The washer must only be used with clean water; use of unfiltered water of corrosive chemicals will damage
the washer.
• Push the motor switch to "OFF" position (FIG. 9)
• Check that the electrical supply voltage and frequency (Volt/Hz) correspond to those specified on the
washer rating plate. If the power supply if correct, you may now plug in the washer.
25
HIGH PRESSURE WASHER
THL014010YL