Telstar THL014010YL Manual De Instrucciones página 26

7. OPERATION
• Turn on the water supply tap fully.
• Release the safety lock (FIG.8) then press the trigger for a few seconds to allow air to escape and to dis-
charge residual pressure in the hose.
• Keeping the trigger pressed, push the switch to start the motor (FIG.9)
• When re-starting the motor, always keep the trigger pressed.
NOTE: THE MOTOR ONLY RUNS WHEN THETRIGGER IS OPERATED.
CORRECT USE OF STANDARD ACCESSORIES
• The washer is equipped with the adjustable nozzle.
• Jet adjustment from pencil to fan (FIG. 10)
WARNING: DO NOT ADJUST THE NOZZLEWHILE THE TRIGGER IS SQUEEZED
RECOMMENDED CLEANING PROCEDURE
• Dissolve dirt by applying detergent with the fan jet to the dry surface. On vertical surfaces, work from the
bottom upwards. Leave the detergent to act for 1 to 2 minutes, but do not allow to dry out. Apply the high
from the surface, working from the bottom upwards.
• Avoid allowing the rinsing water to run on to unwanted surfaces.
STORAGE (FIG.11 – FIG. 13)
• Switch off the washer.
• Turn off the water supply tap.
• After use, the detergent residuals should be removed from the tank.
• Discharge residual pressure by pressing the trigger until no more water comes out of the lance nozzle.
• Engage the gun safety lock.
• Remove the plug from the socket.
• Operate the washer with non-corrosive/ non-toxic antifreeze before storing for the winter.
WARNING: BEFORE REUSING, COMPLETELYFLUSH THE UNIT OUT WITH PLAIN WATER.ANTI-FREEZE CAN DAMAGE
PAINTWORK SOYOU MUST ENSURE THERE IS NOANTI-FREEZE LEFT IN THE SYSTEM BEFOREUSING IT AGAIN.
26
HIGH PRESSURE WASHER
THL014010YL