AquaSource ML-20509 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Sink (A) is heavy and may require additional support
behind the wall for the hanger screws. If necessary,
install a 2 in. × 6 in. board behind the finished wall,
positioning the board flush with the front of the wall
studs.
2. Determine the desired height. Sink (A) should be
installed between 31 in. and 34 in. above the floor. The
center of the slots on the steel hanger (AA) should be
1-1/2 in. lower than the desired height of the sink.
Mark these measurements with a pencil, using a level to
draw a plumb line for the screws. Hold the steel hanger
(AA) level and mark the locations of the holes on the
walls. Check to be sure the marks are level. Mount the
steel hanger (AA) to the wall with two short screws (BB).
Check to see that it is level before fully tightening into
position.
Hardware Used
AA
Steel Hanger
BB
Short Screws
1
2
BB
x 1
x 6
4
Lowes.com
AA
3 in
7.62 CM
WASTE
OUTLET
WALL
FLOOR
DESIRED
HEIGHT
®