Symmons Identity SLS-6710-1.5 Manual De Operaciones Y Mantenimiento página 3

Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON
to relieve water pressure.
1) Insert supply lines (M) and threaded
rods (L) through escutcheon (K)
and sink hole.
M
2) Place rubber washer (N), metal
washer (O) onto threaded rods (L).
Secure with nuts (P).
L
N
O
P
1
Note: Hoses removed for clarity.
3) Seat flange (Q2) into sink. Install
gasket (Q4), washer (Q5) and nut
(Q6) onto flange from below sink,
but do not secure nut. Screw on
tail piece (Q7) and hand tighten.
PLUMBER
PUTTY
OPTIONAL
L
K
4) Turn tail piece (Q7) and flange (Q2)
so pivot is facing toward faucet.
Pull assembly down into drain hole.
Secure hardware from below sink.
Install stopper (Q1) in the remov-
able or non-removable position.
Q1
Q2
2
Q7
1
Q2
Q3
2
2
Q4
Q5
Q6
Q7
3
3
2
PIVOT
1
3
5) Attach inner washer (Q8), pivot rod
(Q9) and outer washer (Q10) to tail-
piece (Q7). Hand tighten nut (Q11)
to secure pivot rod (Q9).
Q10
Q8
Q9
Q7
6) Connect lift rod (F) to clevis strap (Q13)
and secure with thumb screw (Q14).
Insert pivot rod (Q9) through spring
clip (Q12) and clevis strap (Q13).
Secure with spring clip (Q12) and
adjust linkage if necessary.
1
Q13
Q9
Q12
Q11
F
Q14