Progress Lighting AirPro P2546 Manual página 12

Attaching the Switch
Cup Adaptor/
Attaching the Switch
Cup
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Remove one screw from the black bracket
below the fan motor assembly. Loosen, but
do not remove the other two screws. Align
the key hole slots in the switch cup adaptor
with the two screws in the black bracket.
(Figure 14)
2. Turn the switch cup adaptor clockwise until
the two screws are situated in the narrow
end of the keyholes. Re-install the one
screw that was removed in step 1. Tighten
all three screws firmly. (Figure 14)
3. Remove three screws from the switch cup
adaptor. Connect the molded adaptor plug
in the switch cup with the molded adaptor
plug of the fan motor assembly. (Figure 15)
4. Install the three screws that were removed
in step 3. Tighten all three screws firmly.
(Figure 15)
9.
screw
Switch cup adaptor
Screws
Switch cup
Attaching the Fan
with the Optional
Light Fixture (not
supplied)
For optional light fixture installation, remove
the reverse module and the bottom cover to
easily feed the light kit wires through the
switch cup
threaded hole in the center of the switch
adaptor
housing (Figure 16). After the light kit is
attached to the switch cup, replace the module
to its original position.
Figure 14
Figure 15 Figure 16